Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Positive Battery Cable

Courtesy of GENERAL MOTORS CORP.

Install the positive battery cable to the vehicle.
Install the positive battery cable terminal to the mega fuse stud.

Fig 2: Positive Battery Cable Channel, Clips And Studs

Courtesy of GENERAL MOTORS CORP.

Install the positive battery cable clips to the studs on the plenum front panel.

Fig 3: Generator Battery Jumper Cable

Courtesy of GENERAL MOTORS CORP.

Install the generator battery jumper cable terminal (4) to the mega fuse stud.

CAUTION:

Refer to Fastener Caution .

Install the generator battery jumper cable to mega fuse nut (3).
Tighten

Tighten the nuts to 9 N.m (80 lb in).

Fig 4: Mega Fuse Cover

Courtesy of GENERAL MOTORS CORP.

Install the mega fuse cover.

Fig 5: Positive Battery Cable Connector And (UBEC)

Courtesy of GENERAL MOTORS CORP.

Install the positive battery cable connector (1) to the UBEC.

Fig 6: Junction Block

Courtesy of GENERAL MOTORS CORP.

Ensure the junction block retainers are in the open position (1).
Position and align the junction block to the 4 bracket pivots (2), once the pivots are engaged, push the retainer down into the locked position (3).

Fig 7: Under Hood Junction Block Cover

Courtesy of GENERAL MOTORS CORP.

Install the under hood junction block cover.
Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .