LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2012 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 382 (Engine Controls - 4.3L (Introduction)) >> Repair Instructions >> Accelerator Controls Cable Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra and 2004 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the accelerator cable through the front of dash. Snap the accelerator cable cover tangs (1) through the front of dash.
  2. Install the accelerator cable through the slot in the accelerator pedal lever.
  3. Seat the accelerator cable retainer (3) into the accelerator pedal lever (2).
    4. Fig 1: View Of Accelerator Cable Tangs, Pedal Lever & Cable Retainer
    GM372959Courtesy of GENERAL MOTORS CORP.
  4. Install the driver side knee bolster. Refer to Knee Bolster Replacement in Instrument Panel, Gages, and Console.
  5. Connect the accelerator cable to the accelerator control bracket.
    6. Fig 2: View Of Accelerator Cable To Accelerator Control Cable Bracket
    GM781990Courtesy of GENERAL MOTORS CORP.
  6. Connect the accelerator cable to the engine bracket.
  7. Install the accelerator cable slug to the throttle body pulley.
    8. Fig 3: View Of Accelerator Cable Slug At Throttle Body Pulley
    GM781992Courtesy of GENERAL MOTORS CORP.
  8. Install the air cleaner outlet resonator. Refer to Air Cleaner Outlet Resonator Replacement .
scientia non olet · About LEMON Manuals