LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2012 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 382 (Engine Controls - 4.3L (Introduction)) >> Repair Instructions >> Accelerator Controls Cable Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra and 2004 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the air cleaner outlet resonator. Refer to Air Cleaner Outlet Resonator Replacement .
  2. Remove the accelerator cable slug from the throttle body pulley.
    3. Fig 1: View Of Accelerator Cable Slug At Throttle Body Pulley
    GM781992Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the accelerator cable from the accelerator control bracket.
  4. Disconnect and remove the accelerator cable from the engine bracket.
    5. Fig 2: View Of Accelerator Cable To Accelerator Control Cable Bracket
    GM781990Courtesy of GENERAL MOTORS CORP.
  5. Remove the driver side knee bolster. Refer to Knee Bolster Replacement in Instrument Panel, Gages, and Console.
  6. Unseat the accelerator cable retainer (3) from the accelerator pedal lever (2).
  7. Squeeze the accelerator cable tangs (1) together, and push the cable through the front of dash.
    8. Fig 3: View Of Accelerator Cable Tangs, Pedal Lever & Cable Retainer
    GM372959Courtesy of GENERAL MOTORS CORP.
  8. Remove the accelerator cable.
scientia non olet · About LEMON Manuals