10-Minute Learn Procedure
WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
Tools Required
- Tech 2
- Techline terminal with current Service Programming System (SPS) software
- Connect the Tech 2 to the vehicle.
- Select "Request Information" under "Service Programming".
- Disconnect the Tech 2 from the vehicle and connect it to a techline terminal.
- On the techline terminal, select "Theft Module Re-Learn" under "Service Programming".
- Disconnect the Tech 2 from the techline terminal and connect it to the vehicle.
- Turn ON the ignition, with the engine OFF.
- Select "VTD Re-Learn" under "Service Programming".
- Attempt to start the engine, then release the key to ON, vehicle will not start.
- Observe the SECURITY telltale, after approximately 10 minutes the telltale will turn OFF, the vehicle is now ready to relearn the Passlock™ Sensor Data Code and/or password on the next ignition switch transition from OFF to CRANK.
- Turn OFF the ignition, and wait 5 seconds.
- Start the engine, the vehicle has now learned the password.
- With the Tech 2 scan tool, clear any DTCs.