Installation Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Install the wheel speed sensor ring using the J 45860 (1) and the J 8092 (2). See Special Tools .
- Drive the wheel speed sensor ring into the axle housing until the tool bottoms against the tube.
- Install the axle shaft bearing using the J 23690 (1) and the J 8092 (2). See Special Tools .
- Drive the axle shaft bearing into the axle housing until the tool bottoms against the tube.
- Install the axle shaft seal using the J 21128 . See Special Tools .
- Drive the tool into the bore until the axle shaft seal bottoms flush with the tube.
- Install the axle shaft. Refer to Rear Axle Shaft Replacement (8.6, 9.5 LD Axle) or Rear Axle Shaft Replacement (9.5 HD Axle) in Rear Drive Axle.
- Install the rear axle housing cover. Refer to Rear Axle Housing Cover and Gasket Replacement in Rear Drive Axle.
- Install the rear wheel speed sensor. Refer to Rear Wheel Speed Sensor Replacement .
- Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
- Fill the rear axle. Refer to Lubricant Replacement - Rear Drive Axle (8.6 Inch Axle) or Lubricant Replacement - Rear Drive Axle (9.5 Inch LD Axle) or Lubricant Replacement - Rear Drive Axle (9.5 Inch HD Axle) in Rear Drive Axle.
- Lower the vehicle.