Inflatable Restraint Vehicle Rollover Sensor Replacement

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Inflatable Restraint Vehicle Rollover Sensor & Nuts

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
CAUTION: Refer to SIR Caution . Preliminary Procedures Disable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling . Remove the front center floor console bezel assembly, if equipped. Refer to Floor Console Bezel Replacement . Remove the center seat, if equipped. Refer to Center Seat Replacement .
1	Inflatable Restraint Vehicle Rollover Sensor Nut (Qty: 3) NOTE: Refer to Fastener Notice . Tighten: 10 N.m (88 lb in)
2	Inflatable Restraint Vehicle Rollover Sensor Assembly Tip: Reposition carpet and/or wiring harness in order to access sensor. Disconnect the electrical connectors.

Callout

Component Name

CAUTION: Refer to SIR Caution .

Preliminary Procedures

Disable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling .
Remove the front center floor console bezel assembly, if equipped. Refer to Floor Console Bezel Replacement .
Remove the center seat, if equipped. Refer to Center Seat Replacement .

Inflatable Restraint Vehicle Rollover Sensor Nut (Qty: 3)

NOTE: Refer to Fastener Notice .

Tighten: 10 N.m (88 lb in)

Inflatable Restraint Vehicle Rollover Sensor Assembly
Tip:

Reposition carpet and/or wiring harness in order to access sensor.
Disconnect the electrical connectors.