Circuit/System Testing
WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition ON, valet switch OFF, if equipped. Press each button of the GDO one at a time. The LED on the GDO should illuminate with each button pressed.
- If none of the buttons respond, test the battery positive voltage circuit and the ground circuit for an open/high resistance. If the circuits test normal, replace the GDO.
- Ignition ON, hold the 2 outer buttons on the GDO until the LED on the GDO stops flashing. Place the J 41540
adjacent to the GDO and press each button of the GDO one at a time. The tester should indicate when each button is pressed.
- If the tester indicates that one or more of the buttons does not respond, replace the GDO.
- Program the GDO with the customers remote. A possible rolling code or incompatibility with the GDO receiver will prevent programming. Refer to www.homelink.com or 1-800-355-3515.