LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2012 >> Escalade EXT >> Repair and Diagnosis >> Steering >> Power Steering System >> Repair Instructions >> Steering Gear Replacement (Recirculating Ball Without LMM) >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

  1. Install the pitman arm if necessary. Refer to Pitman Arm Replacement .
  2. Position the steering gear in the vehicle.
    3. Fig 1: View Of Steering Gear Bolts
    GM1864179Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Start all of the steering gear bolts by hand and fully seat the bolts before finalizing the torque.

  3. Install the steering gear bolts (1).
    4. CAUTION:

    Refer to Fastener Caution .

  4. Tighten the steering gear bolts to 150 N.m (110 lb ft).
    5. Fig 2: View Of Pitman Arm Nut
    GM1864181Courtesy of GENERAL MOTORS COMPANY
  5. Connect the pitman arm to the relay rod.
  6. Install the pitman arm nut (1) and tighten to 62 N.m (46 lb ft).
  7. Connect the power steering hoses to the steering gear. Tighten the hose fittings to 32 N.m (24 lb ft).
  8. Connect the steering shaft coupling to the steering gear. Refer to Steering Shaft Coupling Replacement .
  9. Install the engine shield, if equipped. Refer to Engine Shield Replacement .
  10. Lower the vehicle.
    11. Fig 3: Locking/Unlocking Steering Column
    GM333146Courtesy of GENERAL MOTORS COMPANY
  11. Remove the J-42640  Pin from the steering column.
  12. Fill and bleed the power steering system. Refer to Power Steering System Bleeding .
  13. Remove the drain pans.
  14. Clean any excess fluid from the vehicle.
scientia non olet · About LEMON Manuals