LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2012 >> SRX AWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> Programming And Setup - All Systems >> Repair Instructions >> Memory Seat Control Module Programming and Setup >> Seat Memory Control Module Programming
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Seat Memory Control Module Programming

To program and setup an existing or new replacement seat memory control module, perform the following procedure:

  1. With a scan tool, access the Service Programming System (SPS) and follow the on-screen instructions. Refer to Service Programming System (SPS) .
  2. On the SPS Supported Controllers screen, select MSM Memory Seat Control Module - Programming and follow the on-screen instructions.

If the MSM Memory Seat Module fails to accept the program, verify all scan tool and seat memory control module connections are secure.

NOTE:

After programming is completed, perform the following to avoid future misdiagnosis:

  1. Turn the ignition OFF for 10 seconds.
  2. Open and close the door.
  3. Connect the scan tool to the data link connector.
  4. Ignition ON, engine OFF.
  5. With a scan tool, clear all DTC's from all modules.

After the seat memory control module programming has been completed and if the vehicle is equipped with adjustable pedals, adjustable pedal calibration must be performed. Refer to Adjustable Pedal System Calibration .

scientia non olet · About LEMON Manuals