Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.

Ignition ON.
Verify DTC P0A3F, P0A40, P0C52, P0C53, P0C5C, P0C5D, or P1B03 is not set.
- If any of the DTCs are set
  Refer to DTC P0A3F, P0A40, P0C52, P0C53, P0C5C, P0C5D, or P1B03 .
- If none of the DTCs are set
Verify DTC P0C4E is not set.
- If the DTC sets
1. Perform each of the operations listed below one at a time until the fault is corrected.
  1. Program the T6 Power Inverter Module.
  2. Replace the M15A Drive Motor 1.
  3. Replace the T6 Power Inverter Module.
2. Repeat the DTC check in step 3.
- If the DTC does not set
All OK.