Conditions for Setting the DTC
WARNING: This page is about a different variant/trim than selected.
Condition 1
- No internal mode switch direction switch DTCs are set.
- A valid internal mode switch direction indicated by the internal mode switch does not match the direction indicated by the hybrid powertrain control module software.
Condition 2
- No internal mode switch direction switch DTCs are set.
- Two valid internal mode switch directions are indicated at the same time.
Condition 3
- One internal mode switch direction switch circuit has failed.
- The hybrid powertrain control module calculates a transmission direction based upon the remaining internal mode switch circuits but it does not match the direction indicated by the hybrid powertrain control module software.
Condition 4
- Multiple internal mode switch directions and one internal mode switch direction switch circuit has failed.
- Based upon the remaining internal mode switch circuits the hybrid powertrain control module calculated two directions at the same time.
Condition 5
- More than one internal mode switch direction circuit has failed and the hybrid powertrain control module cannot calculate a transmission direction.
- Ignition voltage is 9.5-18 V.