LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2013 >> Escalade ESV Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1219 (Data Communication System) >> Diagnostic Information and Procedures >> DTC U209A >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector X2 at the SDGM.
  2. Verify less than 0.5 volts between the wake up signal circuit terminal 19 and ground.
    • If greater than the specified range, test the circuit for a short to voltage. If the circuit tests normal, replace the BCM.
  3. Ignition ON, verify B+ between the communication enable signal circuit terminal 16 and ground.
    • If less than the specified value, test the circuit for an open/high resistance. If the circuit tests normal, replace the BCM.
  4. If all circuits test normal, replace the SDGM.
scientia non olet · About LEMON Manuals