Pedestrian Impact Detection Sensor Replacement - Rear Upper Beam

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Pedestrian Impact Detection Sensor Replacement - Rear Upper Beam

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Disable the pedestrian impact detection system. Refer to Pedestrian Impact Detection System Disabling and Enabling . Remove the front air deflector. Refer to Front Air Deflector Replacement .
1	Pedestrian Impact Detection Sensor NOTE: Refer to Fastener Notice . Procedure Disconnect the electrical connector. Loosen the sensor integral bolt. Tip: The bolt is an integral part of the sensor and should remain with the sensor. Tighten: 10 N.m (89 lb in)

Callout

Component Name

Preliminary Procedures

Disable the pedestrian impact detection system. Refer to Pedestrian Impact Detection System Disabling and Enabling .
Remove the front air deflector. Refer to Front Air Deflector Replacement .

Pedestrian Impact Detection Sensor

NOTE: Refer to Fastener Notice .

Procedure

Disconnect the electrical connector.
Loosen the sensor integral bolt.

Tip: The bolt is an integral part of the sensor and should remain with the sensor.

Tighten: 10 N.m (89 lb in)