LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2013 >> SRX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Battery, Charging System And Starting System) >> Diagnostic Information and Procedures >> DTC P0622 >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

WARNING: This page is about a different car, the 2010 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify that a test lamp illuminates between the G13 generator B+ terminal A X2 and ground.
    • If the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance.
  2. Ignition OFF, disconnect the X1 harness connector at the G13 generator.
  3. Ignition ON, verify the scan tool ECM GEN-F Terminal Signal parameter displays less than 5 percent.
    • If greater than the specified range, test the signal circuit terminal 2 for a short to voltage. If the circuit tests normal, replace the K20 ECM.
  4. Install a 3 A fused jumper wire between B+ and the signal circuit terminal 2.
  5. Verify the scan tool ECM GEN-F Terminal Signal parameter displays greater than 95 percent.
    • If less than the specified range, test the signal circuit terminal 2 for a short to ground or an open/high resistance. If the circuit tests normal, replace the K20 ECM.
  6. If the circuit tests normal replace the G13 generator.
scientia non olet · About LEMON Manuals