Instrument Cluster Scan Tool Information
Instrument Cluster Scan Tool Data Parameters
| Parameter | Expected Value | Description |
|---|---|---|
| Operating Conditions: Ignition ON | ||
| Ambient Air Temperature | 15 °C (59 °F) | The scan tool displays outside temperature in °C (°F). |
| Battery Voltage | 12-14 V | The scan tool displays Volts. This is the current battery voltage signal. |
| Boost Pressure Sensor | 0-100% | The scan tool displays the engine boost pressure filtered. |
| Coolant Level Switch | Open | The scan tool displays either Open, Closed, or Not Available. |
| Driver Information Center Reset Switch | Active/Inactive | The scan tool displays Active or Inactive. This is the state of the driver information center reset switch. |
| Driver Information Center Switch | Varies | The scan tool displays Volts. This is the current driver information center switch input voltage. |
| Driver Information Center Switch | Inactive | The scan tool displays either Inactive, Up, Down, or Menu. This is the state of the driver information center switch. |
| Engine Coolant Temperature | °C (°F) | The scan tool displays actual engine coolant temperature filtered. |
| Engine Oil Pressure | 103 kPa (15 PSI) to 241 kPa (35 PSI) | The scan tool displays the engine oil pressure filtered. |
| Engine Speed | RPM | The scan tool displays the actual engine speed. |
| Fuel Level Sensor | % | The scan tool displays fuel level percent filtered. |
| Key in Ignition Status | Active/Inactive | The scan tool displays Active or Inactive. This is the state of the key in ignition switch. |
| Odometer Lock Status | Active/Inactive | This is the state of vehicle odometer status. |
| Reset Switch | Active/Inactive | The scan tool displays Active or Inactive. This is the state of the reset switch. |
| Vehicle Speed | km/h (MPH) | The scan tool displays the actual vehicle speed. |
| Washer Fluid Level Switch | Open | The scan tool displays either Open, Closed, or Not Available. |
Instrument Cluster Scan Tool Output Controls
| Output Control | Description |
|---|---|
| All Indicators | This function is used to command all the indicators ON or OFF. |
| CAN Bus Configuration Learn | This function is used to Reset the source ID for low speed CAN Bus communications. |
| Driver Information Center Dimming | This function is used to command the dimming of the driver information display to Increase or Decrease by 10%. |
| Driver Information Center Options | This function is used to command the driver information center buttons using the scan tool. |
| Driver Information Center Segments | This function is used to command the driver information center segments ON and OFF. |
| Instrument Cluster Gauge Sweep | This function is used to command the gauges to sweep from minimum to maximum. |
| Instrument Panel Dimmer Switch | This function is used to command the dimming of the instrument cluster to Increase or Decrease by 10%. |
| Odometer Programming | This function is used to command the odometer to reset. |