Installation Procedure

WARNING: This page is about a different car, the 2010 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating Wheel Speed Sensor Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Install the wheel speed sensor connector retainer to the rear suspension cradle.
Connect the wheel speed sensor electrical connector (1).

Fig 2: Identifying Wheel Speed Sensor Harness Retainers

Courtesy of GENERAL MOTORS CORP.

Install the wheel speed sensor harness to the retainers (1).

Fig 3: Identifying Wheel Speed Sensor

Courtesy of GENERAL MOTORS CORP.

Install the wheel speed sensor (1) to the rear suspension knuckle.

Fig 4: Identifying Wheel Speed Sensor Bolt

Courtesy of GENERAL MOTORS CORP.

CAUTION: Refer to Fastener Caution .

Install the wheel speed sensor bolt (1) and tighten to 9 N.m (80 lb in).
Install the rear suspension link. Refer to Rear Suspension Link Replacement - Upper to Lower Control Arm .
Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
Perform the Diagnostic System Check - Vehicle .