LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2014 >> ELR >> Repair and Diagnosis >> Engine Performance >> System >> Data Communication System - DTC B1000 To DTC U183C >> Diagnostic Information and Procedures >> DTC P16B7 >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

NOTE:

Use the schematics and connector end views to identify the device's accessory wake up serial data 2 circuit terminals.

  1. Vehicle OFF, all access doors closed, all vehicle systems OFF, and all keys at least 3 m (9.8 ft) away from vehicle. Disconnect the X1 harness connector at the G1 A/C Compressor. It may take up to 2 min for all vehicle systems to power down.
  2. Vehicle in Service Mode.
  3. Verify that a test lamp illuminates between the accessory wake up serial data 2 circuit terminal 2 X1 and ground.
    • If the test lamp does not illuminate 
    1. Vehicle OFF, disconnect the X2 harness connector at the K114B Hybrid/EV Powertrain Control Module 2.
    2. Test for infinite resistance between the G1 A/C Compressor wake up circuit terminal 2 X1 and the K114B Hybrid/EV Powertrain Control Module 2 wake up circuit terminal 69 X2.
      • If infinite resistance, repair the open/high resistance in the accessory wake up serial data 2 circuit.
      • If less than infinite resistance, replace the K114B Hybrid/EV Powertrain Control Module 2.
    • If the test lamp illuminates 
  4. Replace the G1 A/C Compressor.
scientia non olet · About LEMON Manuals