LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2014 >> Escalade Base, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Object Detection System >> Diagnostic Information and Procedures >> DTC B0967: Parking Aid Switch >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the I/P multifunction switch.
  2. Test for less than 1.0 Ω between the appropriate ground circuit listed below and ground:
    • RPO X88/Z88 ground circuit terminal 3
    • RPO Z75 ground circuit terminal 5
    • If greater than the specified range, test the ground circuit for an open/high resistance.
  3. Ignition ON, verify that the scan tool Park Assist Switch parameter is Inactive.
    • If not the specified value, test the signal circuit terminal 2 for a short to ground. If the circuit tests normal, replace the object alarm module.
  4. Ignition OFF, connect a 3A fused jumper wire between signal circuit terminal 2 and ground.
  5. Ignition ON, verify that the scan tool Park Assist Switch parameter is Active.
    • If not the specified value, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the object alarm module.
  6. If all circuits test normal, test or replace the I/P multifunction switch.
scientia non olet · About LEMON Manuals