LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2014 >> XTS Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 25 (Cellular System, Entertainment System, And Navigation System) >> Diagnostic Information and Procedures >> Unable to Contact OnStar Call Center >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

WARNING: This page is about a different car, the 2013 Cadillac XTS. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • The vehicle may be equipped with sectioned coax. Test each section and replace only the faulty section, not the entire length of coax.
  • The following verification requires the vehicle to be outside with an unobstructed view of the southern sky. Allow 5 min after turning the ignition ON for the GPS satellites to acquire vehicle signal.

Without Navigation Radio

  1. Ignition OFF, disconnect the GPS and cellular coax cable connector at the Telematics Communication Interface Control Module.
  2. Using the EL-49903-3 kit (EL-49903-5 adapter and EL-49903-4 coax cable), connect the EL-49903  GM OnStar antenna diagnostic tool kit to the K73 Telematics Communication Interface Control Module. Place the test antenna on the roof of the vehicle, ignition ON.
  3. Verify the DTC does not set while operating the vehicle within the conditions for running the DTC.
    • If the DTC sets 

      Replace the K73 Telematics Communication Interface Control Module.

    • If the DTC does not set 
  4. Ignition OFF.
  5. Disconnect the EL-49903  GM OnStar antenna diagnostic tool kit from the K73 Telematics Communication Interface Control Module
  6. Connect the GPS and cellular coax cable connector at the K73 Telematics Communication Interface Control Module.
  7. Test the coax cable between the K73 Telematics Communication Interface Control Module and the T4G Cellular Phone, Navigation, and Digital Radio Antenna. Refer to Component Testing .
    • If the coax cable does not pass the test 

      Replace the coax cable.

    • If the coax cable passes the test 
  8. Test or replace the T4G Cellular Phone, Navigation, and Digital Radio Antenna.

With Navigation Radio

  1. Ignition OFF, disconnect the GPS and cellular coax cable connector at the K73 Telematics Communication Interface Control Module.
  2. Using the EL-49903-3 kit (EL-49903-5 adapter and EL-49903-4 coax cable), connect the EL-49903   GM OnStar antenna diagnostic tool kit to the K73 Telematics Communication Interface Control Module. Place the test antenna on the roof of the vehicle, ignition ON.
  3. Verify the DTC does not set while operating the vehicle within the conditions for running the DTC.
    • If the DTC sets 

      Replace the K73 Telematics Communication Interface Control Module.

    • If the DTC does not set 
  4. Ignition OFF, disconnect the EL-49903   GM OnStar antenna diagnostic tool kit. Connect the coax cable to the K73 Telematics Communication Interface Control Module and disconnect the coax cable from the T15 Navigation Antenna Signal Splitter, ignition ON.
  5. Test for 4.5-5.5 V between the coax cable center conductor and the outer shield.
    • If less than 4.5 V 
    1. Ignition OFF.
    2. Test the coax cable. Refer to Component Testing .
      • If the coax cable does not pass the test, replace the coax cable.
      • If the coax cable passes the test, test or replace the K73 Telematics Communications Interface Control Module.
    • If greater than 5.5 V 
    1. Ignition OFF.
    2. Test the coax cable. Refer to Component Testing .
      • If the coax cable does not pass the test, replace the coax cable.
      • If the coax cable passes the test, test or replace the K73 Telematics Communications Interface Control Module.
    • If between 4.5-5.5 V 
  6. Ignition OFF, connect the coax cable to the T15 Navigation Antenna Signal Splitter and disconnect the coax cable from the T4G Cellular Phone, Navigation, and Digital Radio Antenna, ignition ON.
  7. Test for 4.5-5.5 V between the coax cable center conductor and the outer shield.
    • If less than 4.5 V 
    1. Ignition OFF.
    2. Test the coax cable. Refer to Component Testing .
      • If the coax cable does not pass the test, replace the coax cable.
      • If the coax cable passes the test, test or replace the T15 Navigation Antenna Signal Splitter.
    • If greater than 5.5 V 
    1. Ignition OFF.
    2. Test the coax cable. Refer to Component Testing .
      • If the coax cable does not pass the test, replace the coax cable.
      • If the coax cable passes the test, test or replace the T15 Navigation Antenna Signal Splitter.
    • If between 4.5-5.5 V 
  8. Replace the T4G Cellular Phone, Navigation, and Digital Radio Antenna.
scientia non olet · About LEMON Manuals