Circuit/System Verification
- Ignition ON, place the transmission shift lever into manual mode position.
- Verify the scan tool Up and Down Shift Switch 2 parameter displays Upshift, when pushing rearward on the S2R Transmission Manual Shift Switch - Right.
- If the parameter does not display Upshift
Refer to Circuit/System Testing.
- If the parameter does display Upshift
- If the parameter does not display Upshift
- Verify the scan tool, Up and Down Shift Switch 2 parameter displays Down Shift when pushing rearward on the S2L Transmission Manual Shift Switch - Left.
- If the parameter does not display Downshift
Refer to Circuit/System Testing.
- If the parameter does display Downshift
- If the parameter does not display Downshift
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observe from the Freeze Frame/Failure Records data.
- Verify the DTC does not set.
- If the DTC sets
Refer to Circuit/System Testing.
- If the DTC does not set
- If the DTC sets
- All OK.