Circuit/System Verification
- Verify DTCs B0163 and B0183 are not both set concurrently.
- If both DTCs are set
Refer to Low Reference Test.
- If both DTCs are not set
- If both DTCs are set
- Verify DTC B0163, B0183, or B1405 is not set.
- If one of the DTCs is set
Refer to the appropriate diagnostic in Circuit/System Testing.
- If none of the DTCs are set
- If one of the DTCs is set
- Verify the B10B Ambient Light/Sunload Sensor is accurate.
- If the sensor is not accurate
- Perform the following Circuit/System Testing in the order listed below:
- Circuit/System Testing - Low Reference Test
- Circuit/System Testing - DTC B0163
- Circuit/System Testing - DTC B1405
- Circuit/System Testing - DTC B0183
- If the sensor is accurate
- All OK.