LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2015 >> SRX Base, 4D Utility >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Power Door Lock System And Release Systems >> Diagnostic Information and Procedures >> DTC B2500: Driver Exterior Unlock Switch >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the A23D door latch assembly-driver. It may take up to 2 minutes for all vehicle systems to power down.
  2. Test for less than 10 Ω between the ground circuit terminal 8 and ground.
    • If 10 Ω or greater 
    1. Ignition OFF.
    2. Test for less than 2 Ω in the ground circuit end to end.
      • If 2 Ω or greater, repair the open/high resistance in the circuit.
      • If less than 2 Ω, repair the open/high resistance in the ground connection.
    • If less than 10 Ω 
  3. Ignition ON.
  4. Verify the scan tool Driver Door Key Unlock Switch parameter is Inactive.
    • If not Inactive 
    1. Ignition OFF, disconnect the harness connector at the S79D window switch-driver.
    2. Test for infinite resistance between the signal circuit terminal 9 and ground.
      • If less than infinite resistance, repair the short to ground on the circuit.
      • If infinite resistance, replace the S79D window switch-driver.
    • If Inactive 
  5. Install a 3 A fused jumper wire between the signal circuit terminal 9 and the ground circuit terminal 8.
  6. Verify the scan tool Driver Door Key Unlock Switch parameter is Active.
    • If not Active 
    1. Ignition OFF, disconnect the harness connector at the S79D window switch-driver, ignition ON.
    2. Test for less than 1 V between the signal circuit and ground.
      • If 1 V or greater, repair the short to voltage on the circuit.
      • If less than 1 V
    3. Test for less than 2 Ω in the signal circuit end to end.
      • If 2 Ω or greater, repair the open/high resistance in the circuit.
      • If less than 2 Ω, replace the S79D window switch-driver.
    • If Active 
  7. Test or replace the A23D door latch assembly-driver.
scientia non olet · About LEMON Manuals