Circuit/System Verification
- Ignition ON.
- Verify the scan tool Liftgate Front Control Switch parameter changes between Inactive and Active when pressing the liftgate control switch-interior.
- If the parameter does not change
Refer to Circuit/System Testing - Open/Close Switch Circuit Test.
- If the parameter changes
- If the parameter does not change
- Verify the scan tool Liftgate Mode Switch is between 125 counts and 350 counts and changes to 245 counts while rotating the liftgate control switch-interior.
- If not between 125 counts and 350 counts or does not change
Refer to Circuit/System Testing - OFF/ 3/4 position/MAX Switch Circuit Test.
- If between 125 counts and 350 counts and changes
- If not between 125 counts and 350 counts or does not change
- All OK.