Windshield Wiper/Washer Switch

Ignition OFF, disconnect the harness connector at the S82 Windshield Wiper/Washer Switch.
Test for infinite resistance between the signal terminal 1 and the low reference terminal 2 with the high speed switch in the open position.
- If less than infinite resistance
  Replace the S82 Windshield Wiper/Washer Switch.
- If infinite resistance
Test for less than 2 Ω between the signal circuit terminal 1 and the low reference circuit terminal 2 with the high speed switch in the closed position.
- If 2 Ω or greater
  Replace the S82 Windshield Wiper/Washer Switch.
- If less than 2 Ω
Test for infinite resistance between the signal terminal 3 and the low reference terminal 2 with the low speed switch in the open position.
- If less than infinite resistance
  Replace the S82 Windshield Wiper/Washer Switch.
- If infinite resistance
Position the S82 Windshield Wiper/Washer Switch to INT.
Verify the resistance readings are within the specified range listed below between the signal circuit terminal 3 and the low reference circuit terminal 1 by pushing the switch in the listed positions below.
- Delay 1: 3.74-4.00 kΩ
- Delay 2: 2.75-2.85 kΩ
- Delay 3: 1.95-2.05 kΩ
- Delay 4: 1.25-1.35 kΩ
- Delay 5: 765-775 Ω
- If not within the specified range
  Replace the S82 Windshield Wiper/Washer Switch.
- If within the specified range
All OK