Installation Procedure

Multifunction Energy Storage Capacitor Control Module (2)» Install

Fig 1: Multifunction Energy Storage Capacitor Control Module
Courtesy of GENERAL MOTORS COMPANY
Multifunction Energy Storage Capacitor Control Module Nut (1)» Install and tighten Install and tighten 9 N.m (80 lb in) [2x]
CAUTION: Refer to Fastener Caution .
Auxiliary Generator Battery Jumper Cable (2)» Install [3x]

Fig 2: Auxiliary Generator Battery Jumper Cable
Courtesy of GENERAL MOTORS COMPANY
Auxiliary Generator Battery Jumper Cable Nut (1)» Install and tighten 12 N.m (106 lb in) [3x]
Connect the electrical connectors. (3)
Multifunction Energy Storage Capacitor Control Module Bracket (2)» Install

Fig 3: Multifunction Energy Storage Capacitor Control Module
Courtesy of GENERAL MOTORS COMPANY
Multifunction Energy Storage Capacitor Control Module Bracket Bolt (1) Install and tighten 9 N.m (80 lb in) [2x]
Multifunction Energy Storage Capacitor Control Module Bracket Bolt (3) Install and tighten [2x] 9 N.m (80 lb in)
{If equipped} Active Safety Control Module Bracket (2)» Install

Fig 4: Active Safety Control Module
Courtesy of GENERAL MOTORS COMPANY
{If equipped} Active Safety Control Module Bracket Bolt (1)» Install and tighten 2.5 N.m (22 lb in)
Rear Compartment Side Trim Replacement - Left Side » Install
Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
Perform Stop/Start Capacitor Control State Health Reset. Refer to Stop/Start Capacitor Control State of Health Reset