Remote Control Door Lock Receiver Replacement (Copy and Restore TPM Information)

This procedure will learn the TPM information to the new RCDLR using the Copy and Restore function on the scan tool. This procedure will extract the TPM Tire Type information as well as the sensor data from the existing RCDLR prior to its replacement and store this information in the scan tool. After RCDLR replacement and SPS programming, the tire type and sensor data stored in the scan tool is written to the new RCDLR, negating the need to perform the tire type setup and sensor learn procedure.

This procedure should be considered as the first programming choice when replacing an RCDLR. The Copy and Restore procedure eliminates the possibility of incorrectly inputting the tire type or learning stray TPM sensors.

NOTE:

This step must be performed prior to the removal or replacement of the old RCDLR.

1. Using a scan tool, navigate to the Copy and Restore TPM Information procedure and copy the existing TPM information from the RCDLR using the outline below. Follow the on-screen instructions.
   • Remote Control Door Lock Receiver
   • Configure/Reset Functions
   • Copy and Restore TPM Information
2. At this point, install the new RCDLR.
3. Program the RCDLR. Refer to Service Programming System (SPS) .
4. Using a scan tool, navigate to the Copy and Restore TPM Information procedure to restore the TPM information. Follow the on-screen instructions.
5. Program the keyless entry transmitters - Refer to Remote Control Door Lock and Theft Deterrent Transmitter Programming (with ATH - N America and Asia)Remote Control Door Lock and Theft Deterrent Transmitter Programming (with ATH - Canada and Europe) .
6. Perform the 10-Minute Immobilizer Relearn procedure. Refer to Immobilizer System Component Programming (without ATH)Immobilizer System Component Programming (with ATH)

   When performing the relearn procedure, select Theft Deterrent Learn - Keyless Ignition (with rotary switch) on the SPS terminal.