LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2016 >> CTS Base, RWD >> Repair and Diagnosis >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Object Detection System And Pedestrian Protection System - Diagnostic Information And Procedures >> Diagnostic Information and Procedures >> Lane Keep Assist System Malfunction >> Circuit/System Testing >> Lane Keep Assist Switch Circuit Malfunction (without UGN)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Lane Keep Assist Switch Circuit Malfunction (without UGN)

  1. Ignition OFF, disconnect the harness connector at the S48C Multifunction Switch 1 - Instrument Panel. It may take up to 2 minutes for all vehicle systems to power down.
  2. Test for less than 10 Ω between the ground circuit terminal 5 and ground.
    • If 10 Ω or greater 
    1. Ignition OFF.
    2. Test for less than 2 Ω in the ground circuit end to end.
      • If 2 Ω or greater, repair the open/high resistance in the ground circuit.
      • If less than 2 Ω, repair the open/high resistance in the ground connection.
    • If less than 10 Ω 
  3. Ignition ON.
  4. Verify the scan tool Lane Keep Assist switch parameter is Off.
    • If not Off 
    1. Ignition OFF, disconnect the harness connector at the K109 Frontview Camera Module.
    2. Test for infinite resistance between the S48C Multifunction Switch 1 - Instrument Panel signal circuit terminal 6 and ground.
      • If less than infinite resistance, repair the short to ground on the circuit.
      • If infinite resistance, replace the K109 Frontview Camera Module.
    • If Off 
  5. Install a 3 A fused jumper wire between the signal circuit terminal 6 and ground.
  6. Verify the scan tool lane keep assist Switch parameter is On.
    • If not On 
    1. Ignition OFF, disconnect the harness connector at the K109 Frontview Camera Module, ignition ON.
    2. Test for less than 1 V between the signal circuit and ground.
      • If 1 V or greater, repair the short to voltage on the circuit.
      • If less than 1 V
    3. Test for less than 2 Ω in the signal circuit end to end.
      • If 2 Ω or greater, repair the open/high resistance in the circuit.
      • If less than 2 Ω, replace the K109 Frontview Camera Module.
    • If On 
  7. Test or replace the S48C Multifunction Switch 1 - Instrument Panel.
scientia non olet · About LEMON Manuals