Replacing Transmitters (Without SPS)
NOTE:
- This procedure will unlearn all previously learned transmitters. All transmitters that are to be programmed must be with the vehicle at the time of service.
- This procedure will take approximately 30 minutes to complete.
- A total of eight transmitters can be learned to a single vehicle.
- This procedure will only learn the vehicle transmitter information. This procedure will not learn any immobilizer information between the body control module (BCM) and engine control module (ECM).
- This procedure may be used with or without existing learned transmitters being present. If existing transmitters are present, keep the transmitters away from the vicinity of the vehicle. Failure to keep learned transmitters away from the vehicle will result in the learn changing to the Adding Transmitters procedure.
- Insert the mechanical key of the new transmitter into the key lock cylinder located on the outside of the driver door and turn the key to the unlock position five times within ten seconds. The Driver Information Center (DIC) will display Remote Learn Pending, Please Wait.
- After ten minutes, the DIC will display Press Engine Start Button To Learn. Press the ignition mode switch. The DIC will again display Remote Learn Pending, Please Wait.
- Repeat Step 2 two additional times, for a total of thirty minutes. All previously known transmitters have now been unlearned. Remaining transmitters can be relearned during the next steps. The DIC display will now display Ready For Remote #1.
- Place the new transmitter into the transmitter pocket.
- Press and release the ignition mode switch. When the transmitter is learned, the DIC will indicate that it is ready to program the next transmitter.
- Remove the transmitter from the transmitter pocket and press the unlock button. To program additional transmitters, repeat Steps 4 through 6.
- When all additional transmitters are programmed, press and hold the ignition mode switch for 5 seconds to exit programming mode.
NOTE:
The transmitter pocket is located inside the center console storage area, near the front of the storage compartment. The transmitter must be inserted vertically into the pocket with the buttons facing toward the front of the vehicle. If a large keyring prevents the transmitter from being fully inserted into the pocket, remove the keyring and insert the transmitter in the pocket. Failure to fully insert the transmitter into the pocket will result in an inability to program.