LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2016 >> XTS Livery >> Repair and Diagnosis >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Object Detection System And Pedestrian Protection System - Repair Instructions >> Repair Instructions >> Front Parking Assist Alarm Sensor Bracket Replacement
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Front Parking Assist Alarm Sensor Bracket Replacement

  1. Remove the front fascia. Refer to Front Bumper Fascia Replacement .
    2. Fig 1: Front Object Alarm Sensor And Housing
    GM1699865Courtesy of GENERAL MOTORS COMPANY
  2. Disconnect the sensor harness.
  3. Remove the sensor from the sensor bracket.
    4. Fig 2: Sonic Weld Plastic Residue
    GM1699859Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Do Not grind off alignment tabs.

  4. Sand/grind sonic weld plastic residue from the fascia.
    5. Fig 3: Applying Structural Adhesive Epoxy To Fascia
    GM1699866Courtesy of GENERAL MOTORS COMPANY
  5. Apply structural adhesive epoxy, Lord Fusor™ 127EZ or equivalent, to fascia at mating surface.
    6. Fig 4: Sensor Housing And Tabs
    GM1699868Courtesy of GENERAL MOTORS COMPANY
  6. Using the alignment tabs, install the sensor bracket to the fascia.
  7. Allow adhesive to cure according to manufacturer's directions.
    8. Fig 5: Front Object Alarm Sensor And Housing
    GM1699865Courtesy of GENERAL MOTORS COMPANY
  8. Install the sensor to the sensor bracket.
  9. Connect the electrical harness.
  10. Install the front fascia. Refer to Front Bumper Fascia Replacement .
scientia non olet · About LEMON Manuals