Reprogram Control Module
WARNING: This page is about a different car, the 2016 Cadillac CT6. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Some vehicles may be equipped with the handsfree liftgate control option (TC2), it is important to select the correct calibration software for vehicles with or without this option as programming the liftgate with the incorrect software will cause the power liftgate system to become inoperative without any DTCs indicated
To reprogram an existing control module, perform the following procedure:
- Install EL-49642 SPS Programming Support Tool.
- Access the Service Programming System (SPS) and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select Liftgate Control Module - Programming and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select Liftgate Control Module - Setup and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select Liftgate Control Module - Configuration and follow the on-screen instructions.
- At the end of programming, choose the "Clear All DTCs" function on the SPS screen.
- With a scan tool, perform the Liftgate Relearn Refer to Liftgate Calibration