LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2017 >> ATS Base, 4D Sedan, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 264 (Object Detection System And Pedestrian Protection System - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC B095D or B095E: Parking Assist Rear Sensor >> Circuit/System Verification
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Verification

WARNING: This page is about a different car, the 2016 Cadillac CT6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON.
  2. Verify DTC B1405 is not set.
    • If the DTC is not set 
  3. Verify DTC B095D 01, B095E 01, B095D 21, or B095E 21 is not set.
    • If any of the DTCs are set 
    1. Verify none of the B94 Side Object Sensors - Rear are contaminated with snow, mud, dirt, slush, or ice.
      • If contaminated, clean the B94 Side Object Sensors - Rear.
      • If there is no contamination.
    2. Refer to Circuit/System Testing.
    • If none of the DTCs are set 
  4. Verify that DTC B095D 3A or B095E 3A is not set.
    • If any of the DTCs are set 

      Replace the appropriate B94 Side Object Sensor - Rear with the correct sensor type.

    • If none of the DTCs are set 
  5. Ignition ON.
  6. Verify the scan tool Parking Assist System Status parameter is Enabled.
    • If the Parking Assist System Status parameter is Disabled 

      Refer to Circuit/System Testing.

    • If the Parking Assist System Status parameter is Enabled 
  7. All OK.
scientia non olet · About LEMON Manuals