LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2017 >> CT6 Plug-In >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Anti-Theft Systems >> Power Door Lock System And Release Systems - Diagnostic Information And Procedures >> Diagnostic Information and Procedures >> DTC B3265: Trunk Lid Unlatch Output Circuit >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

  1. Ignition/Vehicle & All vehicle systems» Off
    NOTE: It may take up to 2 min for all vehicle systems to power down before an accurate ground or low reference circuit continuity test can be performed.
  2. Disconnect the electrical connector: X2X53A Fuse Block - Rear Body
  3. Test for less than 10 Ω between the test points: Ground circuit terminal 23 X2 & Ground
    • If 10 Ω or greater 
    1. Ground Connection» Disconnect
    2. Test for less than 2 Ω between the test points: Ground circuit terminal 23 X2 & Ground Connection
      • If 2 Ω or greater» Repair the open/high resistance in the circuit.
      • If less than 2 Ω» Repair the open/high resistance in the ground connection.
    • If less than 10 Ω 
  4. Connect the electrical connector: X2X53A Fuse Block - Rear Body
  5. Disconnect the electrical connector: X5K9 Body Control Module
  6. Ignition» On / Vehicle» In Service Mode
  7. Momentarily connect a 3 A fused jumper wire between the test points: Control circuit terminal 11 X5 & B+

    Verify the component turns On and Off when connecting and disconnecting the jumper wire: M40 Rear Compartment Lid Latch

    • If the component does not turn On and Off 
    1. Ignition/Vehicle» Off & Remove» Jumper wire(s)
    2. Disconnect the electrical connector: X2X53A Fuse Block - Rear Body
    3. Ignition» On / Vehicle» In Service Mode
    4. Test for less than 1 V between the test points: Control circuit terminal 11 X5 @ Control module harness & Ground
      • If 1 V or greater» Repair the short to voltage on the circuit.
      • If less than 1 V
    5. Ignition/Vehicle» Off
    6. Test for infinite resistance between the test points: Control circuit terminal 11 X5 @ Control module harness & Ground
      • If less than infinite resistance» Repair the short to ground on the circuit.
      • If infinite resistance
    7. Test for less than 2 Ω between the test points: Control circuit terminal 11 X5 @ Control module harness & Terminal 22 X2 @ Fuse Block Harness
      • If 2 Ω or greater» Repair the open/high resistance in the circuit.
      • If less than 2 Ω» Test or replace the component: X53A Fuse Block - Rear Body
    • If the component turns On and Off 
  8. Replace the component: K9 Body Control Module
scientia non olet · About LEMON Manuals