Removal Procedure

Rear Compartment Lid» Open
WARNING: If a window is cracked but still intact, crisscross the window with masking tape in order to reduce the risk of damage or personal injury.

NOTE: Before cutting out a stationary window, apply a double layer of masking tape around the perimeter of the painted surfaces and inner trim.
Rear window lower seal» Remove
Electrical connectors» Disconnect
Cover to protect the following parts from broken glass:
WARNING: If broken glass falls into the defroster outlets, it can be blown into the passenger compartment and cause personal injury.
- Upper dash pad
- Defroster outlets and A/C outlets
- Seats and carpeting
Using the appropriate tool, carefully cut around the lace, start in the center working from side to side of the window to access the urethane adhesive bead, if equipped.
WARNING: Refer to Glass and Sheet Metal Handling Warning .
This will allow the urethane adhesive to be separated from the window.

Fig 1: Separating Urethane Adhesive From Window
Courtesy of GENERAL MOTORS COMPANY

NOTE: Keep the cutting edge of the tool against the window.
- Leave a base of urethane on the pinchweld flange.
- The only suitable lubrication is clear water.
- BO-24402-A Glass Sealant Remover (Cold Knife).
- BO-39032 Stationary Glass Removal Tool or equivalent in order to remove the window.
With the aid of an assistant lift the rear window (1) from the opening.

Fig 2: Rear Window
Courtesy of GENERAL MOTORS COMPANY