Circuit/System Verification
- Vehicle ON.
- Verify the scan tool hybrid powertrain control module Internal Mode Switch 2 - D1, D2, R1, R2 and S parameters match those in the Internal Mode Switch 2 Parameters table below for each gear selector position. Record any discrepancies.
- If any parameter shows an incorrect state
Refer to Circuit/System Testing.
- If all parameters show correct states
- If any parameter shows an incorrect state
- All OK.
Internal Mode Switch 2 Parameters
| Parameter | Selector Position | ||||
|---|---|---|---|---|---|
| Park | Reverse | Neutral | Drive | Manual | |
| Internal Mode Switch 2 - D1 | HIGH | HIGH | LOW | LOW | LOW |
| Internal Mode Switch 2 - D2 | LOW | LOW | HIGH | HIGH | HIGH |
| Internal Mode Switch 2 - R1 | HIGH | LOW | LOW | HIGH | HIGH |
| Internal Mode Switch 2 - R2 | LOW | HIGH | HIGH | LOW | LOW |
| Internal Mode Switch 2 - S | LOW | HIGH | LOW | HIGH | HIGH |