Circuit/System Verification
NOTE:
To ensure that the steering column lock password from the BCM is learned: turn ignition ON and then OFF, close all doors and wait 5 minutes.
- Ignition ON. Clear all DTCs.
- Verify DTC B2910 does not set while operating the steering column lock module within the conditions for running the DTC.
- If DTC B2910 sets
- Program the K60 Steering Column Lock Module.
- Ignition ON. Clear all DTCs.
- Verify DTC B2910 does not set while operating the steering column lock module within the conditions for running the DTC.
- If DTC B2910 sets, replace the K60 Steering Column Lock Module.
- If DTC B2910 does not set
- All OK.
- If DTC B2910 does not set
- All OK.