LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2017 >> Escalade Base, 4WD >> Repair and Diagnosis (Single Page) >> Body & Frame >> Ignition Switch/Steering Lock >> Wiring Systems And Power Management - Diagnostic Information And Procedures >> Diagnostic Information and Procedures >> DTC B097B: Power Mode Start Switch Circuit >> Component Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Component Testing

  1. Ignition OFF, disconnect the harness connector at the S38 Ignition Mode Switch.
  2. Test for 4.5 - 5.5 kΩ between the terminals listed below with the S38 Ignition Mode Switch released,
    • Signal terminal 6 and ground terminal 4
    • Signal terminal 3 and low reference terminal 7
    • If not between 4.5 - 5.5 kΩ 

      Replace the S38 Ignition Mode Switch.

    • If between 4.5 - 5.5 kΩ 
  3. Test for 1 - 1.5 kΩ between the terminals listed below with the S38 Ignition Mode Switch pressed.
    • Signal terminal 6 and ground terminal 4
    • Signal terminal 3 and low reference terminal 7
    • If not between 1 - 1.5 kΩ 

      Replace the S38 Ignition Mode Switch.

    • If between 1 - 1.5 kΩ 
  4. All OK.
scientia non olet · About LEMON Manuals