Circuit/System Verification
- Verify the vehicle is equipped with OnStar (RPO UE1) and DTC P162B is set
- If the vehicle is not equipped with OnStar (RPO UE1) and DTC P162B is set
Replace the ECM.
- If the vehicle is equipped with OnStar (RPO UE1) and DTC P162B is set
- If the vehicle is not equipped with OnStar (RPO UE1) and DTC P162B is set
- Perform the Remote Vehicle Speed Limiting Reset procedure with the scan tool.
- Verify DTC P162B is not set.
- If DTC P162B is set
- Reprogram the ECM. Refer to Control Module References .
- Verify the DTC does not set while operating the vehicle within the Conditions for Running the DTC.
- If the DTC sets, replace the ECM. If the DTC continues to set after ECM replacement, replace the vehicle communication interface module.
- If the DTC does not set
- All OK.
- If DTC P162B is not set
- All OK.