Circuit/System Verification
- Ignition - On / Vehicle - In Service Mode
- Verify DTC P0231, P0232, P023F is not set.
- If any of the DTCs are set
Refer to: DTC P0231, P0232, or P023F
- If none of the DTCs are set
- If any of the DTCs are set
- Verify the component location is free of debris, clutter or any obstruction that may reduce airflow which could cause an overheat condition:K111 Fuel Pump Driver Control Module
- If a condition exists
- Repair as necessary
- Clear the DTCs.
- Test drive the vehicle.
- Verify DTC P1255 is not set.
- If the DTC sets - Replace the component:K111 Fuel Pump Driver Control Module
- If the DTC is not set
- All OK.
- If no condition exists
- Clear the DTCs.
- Test drive the vehicle.
- Verify DTC P1255 is not set.
- If the DTC is set
Replace the component:K111 Fuel Pump Driver Control Module
- If the DTC is not set
- If the DTC is set
- All OK.