Common Specs & Procedures Index
XTS COMMON SPECS & PROCEDURES
| SYSTEM | SPECIFICATION/PROCEDURE | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | Approximate Fluid Capacities | ||
| Torque | Fastener Specifications | ||
| Wheel Drive Shaft Nut | |||
| First Pass: 150 N.m (111 lb ft) Second Pass: Loosen 45 Degrees Final Pass: 270 (199 lb ft) |
|||
| Battery | N/A | ||
| Brakes | |||
| Bleeding Sequence | RIGHT REAR, LEFT REAR, RIGHT FRONT, LEFT FRONT See Hydraulic Brake System Bleeding (Manual) Or Hydraulic Brake System Bleeding (Pressure) . |
||
| Disc Brakes | |||
| Service Specifications | Disc Brake Component Specifications | ||
| Torque | Fastener Specifications | ||
| Charging | |||
| Generator | N/A | ||
| Torque | Fastener Specifications | ||
| Drive Belts | |||
| Adjustment | Non-Adjustable Serpentine Belt | ||
| Drive Belt Routing | See the Figure Under Drive Belt Replacement | ||
| Engine Cooling | |||
| General Service Specifications | N/A | ||
| Radiator Cap Pressure | Pressure Stamped On Cap | ||
| Thermostat R & I | |||
| 3.6L | Engine Coolant Thermostat Housing Replacement (LGX) | ||
| Water Pump R & I | |||
| 3.6L | Water Pump Replacement (LGX) | ||
| Engine Mechanical | |||
| 3.6L | |||
| Compression | Engine Compression Test | ||
| Oil Pressure | Minimum @ Idle - 69 kPa (10 psi) Minimum @ 2, 000 RPM - 138 kPa (20 psi) |
||
| Overhaul | Engine Mechanical Specifications | ||
| Torque | Fastener Specifications | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE/FLUIDS tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | ||
| Engine Flywheel Bolt Torque | 67 NM (49 lb ft) | ||
| Fuel System | |||
| Pressure Specification | Ignition ON, Engine OFF (Commanded With Scan Tool) - 345-690 kPa (50-100 psi) | ||
| Fuel Pressure Test Procedure | Circuit/System Verification | ||
| Fuel Filter Location | Fuel Filter is Part of the Fuel Tank Fuel Pump Module | ||
| Fuel Filter R & I | Fuel Tank Fuel Pump Module Replacement (FWD) or Fuel Tank Fuel Pump Module Replacement (AWD) | ||
| Ignition | |||
| Firing Order & Cylinder Identification | Firing Order & Cylinder Identification | ||
| Ignition Wires (Resistance) | Individual Ignition Coil/Module Assemblies | ||
| Ignition Wires (Routing) | |||
| 3.6L | Coil On Plug | ||
| Spark Plug - For application, see parts catalog. | |||
| 3.6L | |||
| Gap | LGX 0.90mm (.035 in) | ||
| Torque | 18 N.m (13 lb. ft.) | ||
| Starting | |||
| Starter | N/A | ||
| Torque | Fastener Specifications | ||
| Wheel Alignment | |||
| Adjustment Specifications | Wheel Alignment Specifications | ||
| Torque | Fastener Specifications | ||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 190 N.m (140 ft lb) For Lug Nut Tightening Sequence, Please See the Figure Under Tire and Wheel Removal and Installation |
||