Circuit/System Verification
- Ignition ON/Vehicle in Service Mode.
- Check for updated software in T6 Hybrid Powertrain Control Module.
- If software is not current
Perform the programming procedure for the T6 Hybrid Powertrain Control Module.
- If software is up to date
- If software is not current
- Replace the T6 Hybrid Powertrain Control Module.
- Verify DTC P17CB is not set.
- If DTC P17CB is set
Replace the K38 Chassis Control Module
- If DTC P17CB is not set
- If DTC P17CB is set
- All OK.