Circuit/System Verification
- Verify DTC B389A did not set immediately following the replacement and programming of the K9 Body Control Module.
- If the DTC set immediately after the replacement and programming of the K9 Body Control Module
The immobilizer learn procedure was not properly completed. Perform the BCM immobilizer learn using the body control module IMMO Function with Existing Transponder or Remote Key in SPS. Refer to Immobilizer System Component Programming (without BTM) Immobilizer System Component Programming (with BTM) .
- If the DTC did not set immediately after the replacement and programming of the K9 Body Control Module
- If the DTC set immediately after the replacement and programming of the K9 Body Control Module
- Perform the K9 Body Control Module immobilizer learn using body control module IMMO Function with Existing Transponder or Remote Key in SPS. Refer to Immobilizer System Component Programming (without BTM) Immobilizer System Component Programming (with BTM) .
- Verify DTC B389A does not set after programming.
- If the DTC sets after programming
Replace the K9 Body Control Module.
- If the DTC does not set after programming
- If the DTC sets after programming
- All OK.