LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2017 >> XTS Base >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Controls And Fuel - 3.6L (LFX LF3) - DTC P050D To DTC P2635 And Diagnostic Information And Procedures >> Diagnostic Information and Procedures >> Inspection/Maintenance Complete System Set Procedure >> Inspection/Maintenance (I/M) System Set Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Inspection/Maintenance (I/M) System Set Procedure

  1. Ensure that the vehicle meets the conditions for a cold start listed above.
    • If the EVAP I/M System Status indicator displays NO, perform the EVAP Service bay test if applicable.
  2. Turn OFF all accessories; HVAC system, other electrical loads, including aftermarket/add-on equipment, etc., and open the hood.
  3. Set the vehicle parking brake and ensure the vehicle is in park for automatic transmission or neutral for manual transmission.
  4. Start and idle the engine for 2 min.
    5. WARNING:

    Refer to Road Test Warning .

  5. Close the hood, release the parking brake and Accelerate at part throttle to 72 - 80 km/h (45 - 50 MPH) with this speed maintained until the engine reaches operating temperature, 8 - 10 min.
  6. Continue operation under these conditions for an additional 6 min.
  7. Accelerate at part throttle to 90 km/h (55 MPH) with this speed maintained for 2 min.
  8. Release the accelerator pedal for at least 10 s. This will allow the vehicle to enter the decel fuel cut off.
    9. NOTE:

    Do NOT touch the accelerator pedal until told to do so. A change in throttle position or an increase in engine speed may invalidate this portion of the test.

  9. Safely stop the vehicle, with the engine in drive for automatic or neutral with the clutch pedal depressed and parking brake applied for manual. Allow the vehicle to idle for 2 min.
  10. Shift the vehicle to park for automatic and neutral for manual. Turn OFF the ignition and exit the vehicle. Do NOT disturb the vehicle for 45 min.
  11. Observe the Inspection/Maintenance (I/M) System Status with a scan tool. All of the I/M System Status indicators should display YES.
    12. NOTE:

    An I/M Test DTC will not be stored or erased from the ECU except at the end of trip processing, which occurs 5 s after ignition OFF.

  12. Observe the I/M Test DTC information with a scan tool. Verify there are no I/M Test DTCs present.
  13. Observe the engine DTC information with a scan tool. Verify no DTCs are present.
scientia non olet · About LEMON Manuals