Component Testing

Windshield Wiper/Washer Switch

1. Ignition OFF/Vehicle OFF, disconnect the harness connector at the S82 Windshield Wiper/Washer Switch.
2. Test for infinite resistance between the signal terminal 2 and the low reference terminal 1 with the high speed switch in the open position.
   • If less than infinite resistance 

     Replace the S82 Windshield Wiper/Washer Switch.

   • Go to next step: If infinite resistance 
3. Test for less than 2 Ω between the signal circuit terminal 2 and the low reference circuit terminal 1 with the high speed switch in the closed position.
   • If 2 Ω or greater 

     Replace the S82 Windshield Wiper/Washer Switch.

   • Go to next step: If less than 2 Ω 
4. Test for infinite resistance between the signal terminal 3 and the low reference terminal 1 with the low speed switch in the open position.
   • If less than infinite resistance 

     Replace the S82 Windshield Wiper/Washer Switch.

   • Go to next step: If infinite resistance 
5. Test for the resistance values listed below between the signal circuit terminal 3 and the low reference circuit terminal 1 by cycling the switch between Delay 1 and Delay 5.
   • Delay 1 : 3.8kΩ
   • Delay 2 : 2.8kΩ
   • Delay 3 : 1.9kΩ
   • Delay 4 : 2.8kΩ
   • Delay 5 : 770Ω
   • If not within the resistance values listed 

     Replace the S82 Windshield Wiper/Washer Switch.

   • Go to next step: If within the resistance values listed 
6. All OK

Relay Test

1. Ignition OFF/Vehicle OFF, disconnect the appropriate relay.
2. Test for 60 - 200 Ω between terminals 85 and 86.
   • If less than 60 or greater than 200 

     Replace the relay.

   • Go to next step: If between 60 - 200 Ω 
3. Test for infinite resistance between the terminals listed below:
   • 30 and 86
   • 30 and 87
   • 30 and 85
   • 85 and 87
   • If less than infinite resistance 

     Replace the relay.

   • Go to next step: If infinite resistance 
4. Test for less than 5 Ω between terminals 30 and 87A.
   • If 5 Ω or greater 

     Replace the relay.

   • Go to next step: If less than 5 Ω 
5. Install a 10 A fused jumper wire between relay terminal 85 and 12 V. Install a jumper wire between relay terminal 86 and ground.
6. Test for less than 5 Ω between terminals 30 and 87.
   • If 5 Ω or greater 

     Replace the relay.

   • Go to next step: If less than 5 Ω 
7. All OK