LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2018 >> CT6 Plug-In >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Programming And Setup - All Systems >> Repair Instructions >> K114B Hybrid/EV Powertrain Control Module 2: Programming and Setup >> Programming an Existing Control Module
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Programming an Existing Control Module

To program an existing control module, perform the following procedure:

    CAUTION:

    DO NOT program the K114B Hybrid/EV Powertrain Control Module 2 with the drive Motor battery charger cable connected to the vehicle. Charging while programming may result in damage to the High Voltage Battery Disconnect Relays.

  1. Install the special tool: EL-49642 SPS Programming Support Tool
  2. Access the Service Programming System (SPS) and follow the on-screen instructions.
  3. On the SPS Supported Controllers screen, select K114B Hybrid/EV Powertrain Control Module 2 - Programming and follow the on-screen instructions.
  4. At the end of programming, choose the "Clear All DTCs".
scientia non olet · About LEMON Manuals