Component Testing

Seat Lumbar/Bolster Pump

1. Ignition OFF, disconnect the harness connector at the G31 Seat Lumbar/Bolster Pump.
2. Install a 10 A fused jumper wire between control terminal 1 and 12 V.
3. Momentarily install a jumper wire between the ground terminal 2 and ground. The seat lumbar/Bolster pump should momentarily turn ON.
   • If the pump does not turn ON 

     Replace the G31 Seat Lumbar/Bolster Pump.

   • Go to next step: If the pump turns ON 
4. All OK.