Installation Procedure
Position the front upper control arm (1) on the vehicle.
- CAUTION:
Refer to Fastener Caution .
CAUTION:This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component.
Front Upper Control Arm Bolt (1) - Install NEW and tighten [2x]
- First Pass: 58 N.m (43 lb ft)
- Final Pass: (90 - 105 degrees)
Front Upper Control Arm Ball Stud Nut (1) - Install and tighten to 100 N.m (74 lb ft)
Front Shock Absorber and Spring Assembly (1) - Install - Shock Absorber and Spring Removal and Installation (RWD Without F55) Shock Absorber and Spring Removal and Installation (RWD With F55)
- Measure and adjust the wheel alignment. Wheel Alignment Measurement