Installation Procedure

Courtesy of GENERAL MOTORS COMPANY

Steering Column (1) - Install
Fig 1: Steering Column Nuts With Tightening Sequence
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Support the steering column while installing the steering column nuts.

Steering Column Nut (1) - Install and hand tighten [4x]

CAUTION:

Refer to Fastener Caution .

Steering Column Nut (1) - Tighten in sequence [4x] 22 N.m (16 lb ft)
Connect the steering column electrical connectors.
Courtesy of GENERAL MOTORS COMPANY

Align the relationship marks made between the steering column and the upper intermediate steering shaft (2) during removal.
Upper Intermediate Steering Shaft (2)@Steering Column - Install - Upper Intermediate Steering Shaft Replacement (LGW) Upper Intermediate Steering Shaft Replacement (LTG, LSY) Upper Intermediate Steering Shaft Replacement (LGX, LTA)
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
The anti-rotation pin must be removed from the steering column before installing the steering wheel. Ensure that the steering wheel bolt is torqued to specification during steering wheel installation. Over torquing the steering wheel bolt can result in damage to the steering column rivets which will disable the telescoping mechanism. If the steering column rivets are damaged, a new steering column must be installed.

Remove the device used to prevent steering column rotation.
Steering Wheel (2) - Install - Steering Wheel Replacement
Courtesy of GENERAL MOTORS COMPANY

Floor Front Air Outlet Duct - Left Side (1) - Install - Floor Front Air Outlet Duct Replacement - Left Side
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Lower Airbag Bracket (1) - Install - Instrument Panel Lower Airbag Bracket Replacement
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Knee Bolster (1) - Install - Instrument Panel Knee Bolster Replacement
Courtesy of GENERAL MOTORS COMPANY

Steering Column Lower Trim Cover (1) - Install - Steering Column Lower Trim Cover Replacement
Courtesy of GENERAL MOTORS COMPANY

Driver Monitoring System Camera (1) - Install - Driver Monitoring System Camera Replacement
Courtesy of GENERAL MOTORS COMPANY

Steering Column Upper Trim Cover (1) - Install - Steering Column Upper Trim Cover Replacement (With Driver Monitoring System Camera)
If equipped, install the fuse for the steering column lock control module. The fuse is found in the instrument panel fuse block and is labeled ESCL. Electrical Center Identification Views (1 Of 2)Electrical Center Identification Views (2 Of 2)
Enable the SIR System. SIR Disabling and Enabling
{ If equipped }Program the steering column lock control module. Control Module References
Center the steering angle sensor. Steering Wheel Angle Sensor Centering (without UKL)Steering Wheel Angle Sensor Centering (with UKL)
If battery was disconnected for steering column replacement, wait for all modules to fall asleep. This can be done by closing all vehicle closures (doors, trunk, hood) and waiting for three minutes without actuating any vehicle functions or pushing any buttons.
Perform functionality check of tilt and telescoping features.