Circuit/System Testing

• If 10 ohms or greater 

1. Ground Connection - Disconnect
2. Test for less than 2 ohms between the test points:Ground circuit terminal 2@Component harness & Ground Connection
   • If 2 ohms or greater - Repair the open/high resistance in the circuit.
   • If less than 2 ohms - Repair the open/high resistance in the ground connection.

• Go to next step: If less than 10 ohms 

Verify the component turns On and Off when connecting and disconnecting the jumper wire:M40 Rear Compartment Lid Latch

• If the component does not turn On and Off 

1. Ignition/Vehicle - Off & Remove - Jumper wire(s)
2. Disconnect the electrical connector:X6@K9 Body Control Module
3. Ignition - On / Vehicle - In Service Mode
4. Test for less than 1 V between the test points:Signal circuit terminal 1@Component harness & Ground
   • If 1 V or greater - Repair the short to voltage on the circuit.
   • Go to next step: If less than 1 V
5. Ignition/Vehicle - Off
6. Test for infinite resistance between the test points:Signal circuit terminal 1@Component harness & Ground
   • If less than infinite resistance - Repair the short to ground on the circuit.
   • Go to next step: If infinite resistance
7. Test for less than 2 ohms between the test points:Signal circuit terminal 1@Component harness & Terminal 14 X6@Control module harness
   • If 2 ohms or greater - Repair the open/high resistance in the circuit.
   • If less than 2 ohms - Test or replace the component:K9 Body Control Module

• Go to next step: If the component turns On and Off