Circuit/System Testing
WARNING: This page is about a different car, the 2018 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the navigation antenna coax cable connector at the Performance Data Recorder. Connect the EL-49903 GM OnStar antenna diagnostic tool kit to the K161 Performance Data Recorder, place the test antenna on the roof of the vehicle.
- Ignition ON, infotainment system ON, Performance Data Recorder selected.
- Verify DTC B283D is not set.
- If DTC B283D is set
Replace the K161 Performance Data Recorder.
- Go to next step: If DTC B283D is not set
- If DTC B283D is set
- Ignition OFF, disconnect the navigation antenna coax cable at the T4P Navigation Antenna.
- Verify the navigation coax cable passes the coax cable component test. Refer to Component Testing.
- If the coax cable does not pass the test
Replace the coax cable
- Go to next step: If the coax cable passes the test
- If the coax cable does not pass the test
- Test or replace the T4P Navigation Antenna.