Installation Procedure
- Steering Column (2) - Install
Courtesy of GENERAL MOTORS COMPANY
NOTE:- The upper intermediate steering shaft will not disengage from the steering column entirely until the steering column is removed from the vehicle.When installing the steering column, align the upper intermediate steering shaft with the steering column shaft while positioning the steering column in the vehicle.
- Ensure the match marks on the upper intermediate steering shaft and steering column are aligned.
- Install the steering column nuts (1) and tighten in the sequence shown to 22 N.m (16 lb ft).
- Connect the steering column electrical connectors.
- Fully connect the upper intermediate steering shaft (2) to the steering column.
- Before continuing, ensure the bearings in the intermediate steering shaft boots are positioned correctly and moving freely.
- Upper Intermediate Steering Shaft Bolt (1) - Install
- Thread the cleaned component into the internal mating threads and remove to loosen trapped cured adhesive.
- Apply thread locking adhesive to the external threads of the component. Adhesives, Fluids, Lubricants, and Sealers
- If equipped with ULS, tighten the upper intermediate steering shaft bolt (1) to 30 N.m (22 lb ft).
- If NOT equipped with ULS, tighten the upper intermediate steering shaft bolt (1) to 20 N.m (15 lb ft).
- Release the steering wheel from the method that was used to minimize movement.
- Instrument Panel Knee Bolster Deflector (2) - Install - Instrument Panel Knee Bolster Deflector Replacement
- Windshield Wiper and Washer Switch (1) - Install - Windshield Wiper and Windshield Washer Switch Replacement
- Turn Signal Switch (1) - Install - Turn Signal Switch Replacement
- Enable the SIR System. SIR Disabling and Enabling
- After installation and before the steering column upper and lower trim covers are installed, relearn the soft and hard stops. Steering Column Tilt Wheel and Telescope Control Module Learn
- Steering Column Lower Trim Cover (2) - Install - Steering Column Lower Trim Cover Replacement (With N38) Steering Column Lower Trim Cover Replacement (Without N38)
- Steering Column Upper Trim Cover (2) - Install - Steering Column Upper Trim Cover Replacement
- Install fuse for the steering column lock control module.
- { If equipped }{ ULS } - Program the steering column lock control module. Control Module References
- Center the steering angle sensor. Steering Wheel Angle Sensor Centering
CAUTION:
Refer to Fastener Caution .
NOTE:
In order to relearn the steering column soft and hard stops, the steering column MUST be mounted and fastened and the steering column upper and lower trim covers CANNOT be installed.